For research and educational purposes only. Peptides are not approved for human use unless specifically indicated. Read full disclaimer.
PeptideHub
Dosage guide

Selank dosage: research ranges, units, and cycle

The complete Selank dosing reference. Common research ranges, unit-conversion tables for U-100 syringes at multiple concentrations, cycle protocols, and a built-in calculator.

Research dose
250–3000 mcg
Frequency
2× / day
Cycle
4w on / 2w off

Selank typical research dosing

Across the available literature, Selank is most commonly administered at 2503000 mcg per dose, 2 time(s) per day, via nasal injection. Selank is most commonly used as an intranasal solution (0.15% concentration). Research protocols vary from 250 mcg to 3 mg per day divided into 2–3 intranasal administrations. Clinical studies in Russia used 250–900 mcg daily for anxiety disorders.

Selank unit-conversion table

The number of insulin-syringe units you draw depends on how much bacteriostatic water you used to reconstitute the vial. The table below shows units to draw on a U-100 syringe for a 0.25 mg Selank vial at common reconstitution volumes.

Diluent (mL)Concentration250 mcg1625 mcg3000 mcg
1 mL250 mcg/mL100.0 units650.0 units1200.0 units
2 mL125 mcg/mL200.0 units1300.0 units2400.0 units
3 mL83 mcg/mL300.0 units1950.0 units3600.0 units
5 mL50 mcg/mL500.0 units3250.0 units6000.0 units

Selank cycle length

Most reported Selank protocols run 4 weeks on, then 2 weeks off. Cycles are used in research to study washout, receptor sensitivity, and to re-baseline endogenous signaling before re-introducing the compound.

Selank half-life and timing

Selank has a half-life of approximately 0.033 hours. This influences dose frequency: shorter half-lives often require multiple doses per day to maintain steady-state levels, while longer half-lives can be dosed less frequently.

Selank dosage calculator

Common research range for Selank: 2503000 mcg, 2× daily, nasal. Cycle: 4 weeks on / 2 off.

Educational use only. This calculator performs unit math on the values you provide and is not a substitute for medical advice. Verify every calculation independently.

Result

Concentration
250 mcg / mL
Per syringe unit
2.50 mcg / unit
Draw to this mark
650.0 units (6.50 mL)
Exceeds 100 units — use less diluent or a larger syringe.
Dose, all units
1625 mcg · 1.625 mg
Doses per vial
0.2 doses
Days per vial
0.1 days
Vials needed for 4-week cycle
364 vials

Numbers are computed from your inputs. Verify all calculations independently. Educational use only.

Selank dosage FAQ

What's the standard Selank dose?+

Research protocols commonly use 250–3000 mcg per administration, 2× per day, via nasal injection. Individual study designs vary.

How long is a typical Selank cycle?+

4 weeks on, 2 weeks off is the most commonly reported research cycle.

How do I convert Selank mcg to insulin syringe units?+

Reconstitute the 0.25 mg vial with 1 mL bacteriostatic water for 250 mcg/mL. On a U-100 syringe, 1 unit = 2.5 mcg. Use the calculator on this page to compute exactly.

What time of day should I administer Selank?+

Timing varies by protocol. Some researchers split doses to maintain steady levels; others administer post-workout or pre-bed. Consistent timing improves research-quality observations.

What's the difference between mcg and mg for Selank?+

1 mg = 1,000 mcg (micrograms). Most Selank research doses are in mcg because the bioactive amount is small relative to vial size. A 0.25 mg vial contains 250 mcg total.