For research and educational purposes only. Peptides are not approved for human use unless specifically indicated. Read full disclaimer.
PeptideHub
Dosage guide

Tirzepatide dosage: research ranges, units, and cycle

The complete Tirzepatide dosing reference. Common research ranges, unit-conversion tables for U-100 syringes at multiple concentrations, cycle protocols, and a built-in calculator.

Research dose
2500–15000 mcg
Frequency
1× / day
Cycle
20w on / 0w off

Tirzepatide typical research dosing

Across the available literature, Tirzepatide is most commonly administered at 250015000 mcg per dose, 1 time(s) per day, via subcutaneous injection. Clinical escalation: 2.5 mg weekly for 4 weeks, then 5, 7.5, 10, 12.5, 15 mg at 4-week intervals as tolerated.

Tirzepatide unit-conversion table

The number of insulin-syringe units you draw depends on how much bacteriostatic water you used to reconstitute the vial. The table below shows units to draw on a U-100 syringe for a 10 mg Tirzepatide vial at common reconstitution volumes.

Diluent (mL)Concentration2500 mcg8750 mcg15000 mcg
1 mL10000 mcg/mL25.0 units87.5 units150.0 units
2 mL5000 mcg/mL50.0 units175.0 units300.0 units
3 mL3333 mcg/mL75.0 units262.5 units450.0 units
5 mL2000 mcg/mL125.0 units437.5 units750.0 units

Tirzepatide cycle length

Most reported Tirzepatide protocols run 20 weeks on, then 0 weeks off. Cycles are used in research to study washout, receptor sensitivity, and to re-baseline endogenous signaling before re-introducing the compound.

Tirzepatide half-life and timing

Tirzepatide has a half-life of approximately 120 hours. This influences dose frequency: shorter half-lives often require multiple doses per day to maintain steady-state levels, while longer half-lives can be dosed less frequently.

Tirzepatide dosage calculator

Common research range for Tirzepatide: 250015000 mcg, 1× daily, subcutaneous. Cycle: 20 weeks on.

Educational use only. This calculator performs unit math on the values you provide and is not a substitute for medical advice. Verify every calculation independently.

Result

Concentration
5000 mcg / mL
Per syringe unit
50.00 mcg / unit
Draw to this mark
175.0 units (1.75 mL)
Exceeds 100 units — use less diluent or a larger syringe.
Dose, all units
8750 mcg · 8.750 mg
Doses per vial
1.1 doses
Days per vial
1.1 days
Vials needed for 20-week cycle
123 vials

Numbers are computed from your inputs. Verify all calculations independently. Educational use only.

Tirzepatide dosage FAQ

What's the standard Tirzepatide dose?+

Research protocols commonly use 2500–15000 mcg per administration, 1× per day, via subcutaneous injection. Individual study designs vary.

How long is a typical Tirzepatide cycle?+

20 weeks on, 0 weeks off is the most commonly reported research cycle.

How do I convert Tirzepatide mcg to insulin syringe units?+

Reconstitute the 10 mg vial with 2 mL bacteriostatic water for 5000 mcg/mL. On a U-100 syringe, 1 unit = 50.0 mcg. Use the calculator on this page to compute exactly.

What time of day should I administer Tirzepatide?+

Timing varies by protocol. Some researchers split doses to maintain steady levels; others administer post-workout or pre-bed. Consistent timing improves research-quality observations.

What's the difference between mcg and mg for Tirzepatide?+

1 mg = 1,000 mcg (micrograms). Most Tirzepatide research doses are in mcg because the bioactive amount is small relative to vial size. A 10 mg vial contains 10000 mcg total.